Install Pcset Software - Reiner jetStamp 990 Mode D'emploi

jetStamp 990
Push the locking bracket
f
Unpack the new print cartridge
f
instructions for the print cartridge P1).
Insert the print cartridge into the print carriage
f
Pull the locking bracket
f
Push [SELECT]
f
The print carriage moves to its basic position. In order to get right to the next menu item,
push - OR - to leave the main menu, push [RETURN].
The selected print image appears.

1.2. Install PCset Software

Installation is only possible with administrator rights on the computer.
Insert installation medium USB stick in your PC.
f
If the installation programme does not start up automatically, start the file „Setup_PC-
f
set.exe".
Observe the installation programme instructions.
f
1.3. Firmware update
The most up to date firmware for the jetStamp 990 can be downloaded from www.reiner.de.
1.4. Recognising and Removing Interferences
For more information, see the online help of the PCset software, or the enclosed USB.
Contact
Ernst Reiner GmbH & Co. KG
Baumannstr. 16
78120 Furtwangen / Germany
Phone: +49 7723 657-0
reiner@reiner.de
www.reiner.de
© 2020 Ernst Reiner GmbH & Co. KG
All rights reserved. Translation, reprint and other reproduction of these operating. Instruc-
tions, even in parts and no matter the form, shall require our express written consent. We
reserve the right to make content changes to these operating instructions without notice.
8
into the rear-most position.
7
and remove the protective film or clip (see operating
8
forward again.
7 16
at the grip strip .
GB
10