Replacement Parts; Extension Cord - Stanley MRC2 Manuel D'utilisation

24. DO NOT MODIFY THE COMPRESSOR Do not modify the compressor. Always contact the
authorized service center any repairs. Unauthorized modification may not only impair the compressor
performance but may also result in accident or injury to repair personnel who do not have the required
knowledge and technical expertise to perform the repair operations correctly.
25. TURN OFF THE PRESSURE SWITCH WHEN THE COMPRESSOR IS NOT USED When the
compressor is not used, turn the knob of the pressure switch OFF, disconnect it from the power source
and open the drain cock to discharge the compressed air from the air tank.
26. NEVER TOUCH HOT SURFACE To reduce the risk of burns, do not touch tubes, heads, cylinder
and motors.
27. DO NOT DIRECT AIR STREAM AT BODY Risk of injury, do not direct air stream at persons or
animals.
28. DRAIN TANK Drain tank daily or after 4 hours of use. Open drain fitting and tilt compressor to
empty accumulated water.
29. DO NOT STOP COMPRESSOR BY PULLING OUT THE PLUG Use the "AUTO/OFF" knob of
pressure switch.
30. USE ONLY RECOMMENDED AIR HANDLING PARTS ACCEPTABLE FOR PRESSURE NOT LESS
THAN 125 PSI (8.6 BAR) Risk of bursting. Use only recommended air handling parts acceptable for
pressures not less than 125 psi ( 8.6 bar).

REPLACEMENT PARTS

When servicing use only identical replacement parts. Repairs should be conducted only by authorized
service center.

EXTENSION CORD

Use only three-extension cords that have three-prong grounding type plugs and three-pole receptacles
that accept the compressor's plug. Replace or repair damaged cord. Make sure your extension cord is
in good condition. When using an extension cord, be sure to use one heavy enough to carry the current
your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power
and overheating. Table shows the correct size to use depending on cord length and name plate ampere
rating. If in doubt, use the next heavier gage. The smaller the gage number, the heavier the cord.
Tab.1 SECTION VALID FOR A MAX LENGTH OF 20 mt single-phase
CV kW
0.75-1 0.65-0.7
1.5 1.1
2 1.5
2.5-3 1.8-2.2
WARNING
Avoid electrical shock hazard. Never use this compressor with a damaged or frayed electrical cord or
extension cord. Inspect all electrical cords regularly. Never use in near water or in any environment
where electric shock is possible.
220/230V 110/120V
mm 2 mm 2
1.5 2.5
2.5 4
2.5 4-6
4 -