Insert/Replace Batteries; Weight Only / "Step On" Function; Operating - Medisana PSB Mode D'emploi

GA_40410_PSB_West_aktual.qxd:Personenwaage
GB

3 Operating

3.1
Insert/replace
batteries
3.2
Weight only /
"step on" function
18
Before you start up your digital scale, insert the two provided cell batteries
(type CR2032) into the device. To do this, open the battery compartment
beneath the device and insert the batteries. Please note polarity (positive
pole upwards as shown on the lid of the battery compartment). Close the
battery compartment again. Replace the batteries if the battery change sym-
bol "Lo" appears in the display
the device is switched on.
WARNING BATTERY SAFETY INFORMATION
• Keep away from children!
• Do not recharge!
• Do not short-circuit!
• Do not throw into fire!
There is a danger of explosion!
• Do not dispose of old batteries with your household waste,
but dispose of them at a battery collection station at a
recycling site or in a shop!
1. Stand the scales on a firm, even
floor. Step onto the scales and
stand still.
2. The unit switches on
automatically and "0.0 kg"
appears briefly on the display
3. Your weight is measured and
displayed
(in the example shown: 68 kg).
4. Step down from the scales. The display changes to "0.0 kg". The scales
turn off automatically after 36 secs if no further operation is performed.
Alternatively, you may switch the scales on with the ON button
onto the scales and read off your weight; the weight display flashes twice
before the scales switch off automatically.
26.05.2009 13:25 Uhr
or if nothing appears in the display when
.
Seite 18
, step