Care And Maintenance; Warranty Conditions; Disposal - EUROM Advanced Mode D'emploi

EN
put on the safety of the pistol trigger whenever
the machine is stopped, in order to avoid
unintentional starting.
· Any automatic start of the machine without
pressing the gun trigger is attributable to air
bubbles in the water or other similar phenomena
which do not imply the existence of any defects in
the machine.
· Do not leave the appliance unattended during
the standby for more than 5 minutes. Contrarily,
for the safety of the appliance it is necessary to
re-turn the switch into the (0) OFF position.
· Please check that the coupling of the high
pressure hose with the appliance and the gun
supplied as standard equipments made correctly,
that is to say without any water leak.
> SwITCHING OFF
See fig.
turn the switch pos. 2 (0) OFF position and wait that
the water get completly cold.
In this way you avoid any calcareous deposit and
overheatings of the coil and the boiler, which are al-
ways dangerous.
IMPORTANT: When the machine is switched
off, always discharge the pressure hose, opening
the gun.

CARE AND MAINTENANCE

See fig.
• x x WARNING: the machine shall be
disconnected from its power source, by
removing the plug from the
outlet, during cleaning or maintenance
• WARNING: Do not spray the appliance
with water and do not use detergents or
aggressive solvents. Machine could be
damaged.
·
Clean the exterior part of the machine with a dry
cloth.
- Always keep the machine clean so that the
cooling air can pass through the slits without
obstructions..
- Cleaning the water filter: To ensure the pump gives
good service it is extremely important to check
and clean the water filter frequently. Use pliers to
extract it from the pump and rinse it carefully in
running water.
- Cleaning the nozzle: A blockage in the nozzle may
prevent the machine from operating correctly, so
it must be kept clean. Switch off the machine and
16
remove the lance. Clean the nozzle with the pin
provided. Rinse the lance in running water.
- When topping up the oil in the pump, use a SAE
20W40 mineral oil. Quantity supplied: 70 gr.
- The replacement of the fuel metal pipe is requested
after disassembling to avoid fuel leakages.
> STORAGE
See fig.
· Move the machine only by grasping the
carrying handle
· Store the appliance and the accessories in a
frost-safe room.

WARRANTY CONDITIONS

All our machines are subjected to strict tests
and are covered against manufacturing de-
fects in accordance with applicable regula-
tions. The warranty is effective from the date of
purchase. The following are not included in
the warranty: - Parts subject to normal wear.
- Rubber parts, charcoal, filters and the acces-
sories and optional accessories. - Accidental
damage, caused by transport, neglect or ina-
dequate treatment, incorrect or improper use
and installation failing - The warranty shall not
cover any cleaning operations to which the
operative components may be subjected, such
as clogged nozzles and filter blocked due to li-
mestones. This pressure cleaner is intended to
be used for domestic and hobby work: the war-
ranty does not cover any other different kind
socket-
of use.
DISPOSAL (WEEE)
As the owner of electrical or electronic
equipment, the law (in accordance with
the EU Directive 2002/96/EC of 27 January 2003)
prohibits you from disposing of this product or
its electrical / electronic accessories as munici-
pal solid waste and obliges you to make use of
the appropriate waste collection facilities.
The product can be disposed of by returning it
to the distributor when a new product is pur-
chased. The new product must be equivalent
to that being disposed of.