Usage - EUROM Advanced Mode D'emploi

EN
> STABILITY
• WARNING:
The machine must be always kept
on horizontal bases, in a safe and stable way.

USAGE

> DESCRIPTION OF THE MACHINE
See pag.3-4-5.
> ASSEMBLY INSTRUCTIONS
See pag.2.
> PUT INTO SERVICE
See fig.
* Check that the master switch is turned to
"OFF" and that the water filter is fitted into
the pump's inlet pipe.
* Screw the snap connection into place by
hand, without the aid of tools.
* Connect the water supply hose to the snap
connection. The hose must have an inside
diameter of at least 13 mm (1/2").
* Connect the high pressure hose to the
pump's outlet pipe. Press the high pressure
hose coupling fully down and then screw
into place by hand without the aid of tools.
* Connect the high pressure hose to the gun.
* Turn the water tap fully on. The water
temperature absolutely must be below
40°C.
IMPORTANT: The washer machine has to
operate with clean water in order to avoid
any damages to the washer machine itself.
* Release the gun safety catch and keep the
trigger pressed, allowing the water to flow
until all the air has been expelled.
* Fit the lance into the gun.
* Connect the plug to the power socket.
* To start the machine, press the gun trigger
and at the same time turn the master switch to
"ON".
FILLING UP
Fill up the tank with the fuel indicated on the
technical data plate.
Avoid that the tank is empty when the ma-
chine is running in order not to damage the
fuel pump.
•WARNING: Incorrect fuel shall not used as
they as provide hazard.
Fill up the detergent tank with the suggested pro-
ducts, suitable for the kind of washing to be carried
out .
•WARNING: make use only of liquid
detergent, do not absolutely use acid or too
14
much alkaline products.
We suggest you to make use of our products, which
have been studied for the use with washer machi-
nes.
> STARTING UP
See fig.
Start the machine:
turn the switch pos. 2 ( I )ON.
To wash with hot water:
turn the switch pos. 2 .
The burner operates when the machine is in pres-
sion.
> HIGH PRESSURE LANCE
See fig.
> DETERGENT SUCTION
See fig. - -
> HIGH PRESSURE HOSE
See fig.
> WATER SUPPLY
Water supply collection
Water supply from the water main
· Connect a supply hose (not included) to the water
inlet of the unit and to the water supply.
· Open the water supply.
WARNING: (symbol) machine not suitable for
connection to the potable water mains.
The cleaner can only be connected to the wa-
ter mains if the water mains is separated by a
backflow preventer. Make sure that the hose
is at least Ø 13mm-1/2 inch and that it is rein-
forced.
W ARNING: Water that has flown through
•
backflow preventers is considered to be
nonpotable.
IMPORTANT: Only clean or filtered water
should be used for intake. The delivery of
the water intake tap should be equal to the
double of the maximum pump range.
- Minimum delivery rate: 15 l/ min.
- Maximum intake water temperature: 40°C
- Max inlet water pressure: 1Mpa
Place the cleaner as close to the water supply
system as possible.
Water supply from an open container