Driving The Scooter; Pushing Mode - B+B Centuro S7 Mode D'emploi

Centuro S7
| Scooter

4.3. Driving the scooter

You should make your first journey on a level site with ample space
• Ensure that you are sitting correctly on your scooter. Set the speed
as low as possible. You can increase the speed when you are more
familiar with handling the scooter.
22
• To switch on your scooter, insert the ignition key into the ignition
lock on the control panel and turn the key a quarter turn to the
right.
• To switch off the scooter, turn the key a quarter turn to the left.
After getting out of the scooter, always ensure that you have
removed the ignition key and do not leave the scooter unattended
with the ignition key inserted.
• Please make sure that you do not have your hand on the forwards
/backwards lever when you switch on your scooter. This would
cause your scooter to display an error message. In this case, turn it
23
off and then on again to rectify this error.
• Pull back the speed selection lever on the right to move forwards
(Fig 22). The further you pull back the lever, the higher the speed.
The speed can go up to the maximum speed that has been preset
using the speed control. Release the lever to stop gently. Practice
these two procedures in order to get used to them.
• Steering is easy and works exactly like a bicycle in that you turn the
handlebars in the direction in which you wish to move. Leave plenty
24
of distance when you travel around a curve so that the rear wheels
are able to follow the path of the front wheels and so that you do
not cut across objects.
54
It is necessary to pay attention when reversing (fig 23). Ensure that
your speed is low before reversing. Please keep in mind that you need
to steer in the opposite direction when you are reversing. This requires
practice. Practice this also on a level site with ample space.
Please note that, for safety reasons, the reversing
speed is only half the speed going forward.
• If you turn sharply, turn the handlebars before you accelerate.
Always drive in a wide arc around corners and obstacles and ensure
that you drive slowly and carefully. For your own safety, the scooter
automatically reduces the speed when cornering.
• When the drive is connected, the brake is automatically applied
when the throttle lever is released. The scooter then cannot be
pushed or displaced because the brake is automatically applied to
the motor.

4.4. Pushing mode

If you want to push the scooter in certain situations, you must unlock
the brakes. It is easy to push the scooter in free wheel mode.
The electro-mechanical brake will then not operate.
• Pull the unlocking lever in the back (Fig 24) downwards.
• A small jerk will indicate that the drives are now unlocked.
• To lock, simply push the lever up and locking then takes place
automatically.
• The engine has a centrifugal clutch, the brake blocks automatically
should you accelerate the scooter too hard in overrun cutoff. Only
after a coming to a complete standstill will it be released.
Bischoff & Bischoff GmbH |28.07.2020 - revision 3
Centuro S7
Scooter |
25
26
55