LGB 64192 Mode D'emploi page 7

GB
USA
American Diesel
Locomotive
THE PROTOTYPE
The Davenport Corporation built
diesel-mechanical switchers for
numerous railroads throughout
the world.
THE MODEL
This detailed model features:
- weather-resistant construction
- opening cab doors
- retracting cab awnings
- power control switch
- protected gearbox with seven-
pole Bühler motor
- four powered wheels
- one traction tire
- six power pickups
- voltage stabilization circuit
- automatic directional lighting
- multi-purpose socket
- length: 310 mm (12.2 in)
- weight: 2100 g (4.6 lb)
THE PROGRAM
With this model, we recommend
the following items:
- 41770 Disconnect Log Trucks,
Oxide Red, 3 pair
- 42660 Sumpter Valley Log Car
- 46660 Sumpter Valley Flatcars,
2 pieces
- 44760 PRR Hopper Car
- 46915 PRR Steel Boxcar
For information on the complete
LGB program, see the LGB cata-
log.
OPERATION
Preparation
Front coupler: The model may
be equipped with a working
knuckle coupler on the front. Addi-
tional couplers (LGB 64192) are
available. A standard LGB coupler
is included. To replace the front
coupler, remove the screw at the
bottom of the coupler and install a
new coupler (Fig. 1).
Operating Modes
This model has a four-way power
control switch inside the cab (Fig.
1a, 1b):
Position 0: All power off
Position 1: Power to lights
Position 2: Power to lights and
motor
Position 3: Power to lights and
motor (factory pre-set)
Multi-Train System
This model has a direct decoder
interface. It can be equipped with
an LGB Multi-Train System Deco-
der (55020). The Decoder Interfa-
ce Cable (55026) is not required.
We strongly recommend decoder
installation by an LGB service
station. For more information,
contact your authorized LGB
retailer or an LGB service station
(see Authorized Service).
Hint: If this model is equipped
with a decoder, the digital/analog
DIP switches on the loco circuit
board will be set to OFF. The DIP
switches should remain in this
setting, even if the model is used
on an analog layout.
Lighting
This model features directional
lighting. The model has a "flat"
multi-purpose socket (Fig.2), with
a removable cover, on the rear of
the cab. This socket can be used
to provide track power to cars with
lighting or sound electronics.
To remove the cover of the
socket, pull it straight out. If the
cover is tight, gently use a small
straight screwdriver to pry it out.
(Do not pull out the rectangular
outer housing.)
Power Supply
Attention! For safety and reliabi-
lity, operate this model with LGB
power supplies (transformers,
power packs and controls) only.
The use of non-LGB power sup-
plies will void your warranty.
Use this model with LGB power
supplies with an output of at
least 1 amp. For more informati-
on on LGB power supplies for
indoor, outdoor and multi-train
operation, see the LGB catalog.
Attention! After extended opera-
tion, this model may leave carbon
dust or other debris around the
7