Building Into A New Hearth - Dovre ZEN 100 Installation Et Mode D'emploi

Chamotte inner plates are ochrous on delivery.
They insulate the combustion chamber to
boost combustion.
3
4
5
Pos. Description
1 side inner plate
2 inner plate front and rear
3 air guide
4 stove base
5 vents
To remove the inner plates and the stove base, follow
the instructions below; see previous figure.
1. Remove the air guides (3) on the left and right
sides.
2. First remove both inner plates (1) on the sides by
tipping them forwards and removing them from the
appliance via the door opening.
3. Remove the inner plates (2) at the front and rear.
4. Remove the stove base (4).
When reassembling the stove base, make sure
the two vents (5) are facing forward.
Prepare
connection to outside air
If the appliance is installed in a room with insufficient
ventilation, you can install the outside air connecting
kit to the appliance.
The air supply tube is 100 mm in diameter. If the tube
is smooth, it may be no longer than 12 metres. If
accessories such as bends are used, the maximum
10
1
2
1
3
09-20020-309
length (12 m) must be reduced by 1 m for each access-
ory used.
Outside air intake duct through the
wall or the floor and the connection
collar
1. Make a hole in the wall or the floor (refer to
Appendix 2, "Dimensions" for a suitable position
of the hole).
2. Close the air connection tube hermetically on the
wall.

Building into a new hearth

The fireplace insert is installed in two stages:
Placing and connecting the fireplace
Building up the hearth around the fireplace.
Placing and connecting the fire-
place insert
1. Place the appliance at the right height, flat and
level.
You may wish to use the optional legs and
stays.
2. Make sure there is sufficient space between the
existing walls (insulated as per instructions) and
the rear of the appliance.
3. Connect the appliance to the flue hermetically.
4. Check the draught in the flue and the seal of the
connection on the flue gas duct by making a small,
intense trial fire with newspaper and dry, small
kindling.
Wait until new masonry has dried sufficiently.
5. For outside air supply connection: connect the out-
side air supply to the connection kit you fitted to
the appliance.
Building the fireplace
Inside the hearth you provide space for convection. In
this space the air must be able to move freely. It must
be possible for air to be drawn in for combustion pur-
poses, and the air heated by the built-in fireplace (the
Subject to change because of technical improvements