Installation; General Preparation - Dovre ZEN 100 Installation Et Mode D'emploi

12. Threaded rod M8 (optional)
13. Finishing cover

Installation

General preparation

Please check the appliance immediately after deliv-
ery for damage during transport or any other dam-
age or defects. The appliance is attached to the
pallet with screws at the bottom.
If you detect transport damage or any other
damage or defects, do not use the appliance
and notify the supplier.
Remove the detachable parts from the appliance
before you begin its installation.
It is easier to move the appliance and to avoid
damage if the removable parts have been
removed.
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
Open door
Open the door by pulling the handle forward and
unlocking the door; see next figure.
As the latch button becomes warm during use
of the appliance, a glove has been supplied
which you can use to protect your hand.
Subject to change because of technical improvements
Remove fire-resistant inner plates
6
2
1
Pos. Description
1
2
3
4
5
6
7
8
To remove the inner plates, follow the instructions
below; see previous figure.
1. First remove the inner plates on the side (1),(2),(4)
and (5) by lifting these up and out of the appliance
via the door opening.
2. Remove both inner plates (6).
3. Remove the inner plate (3).
4. Remove both baffle plates (7) from the baffle plate
holder (8).
5. Remove the baffle plate holder (8).
09-20020-307
Remove stove base
The stove base is protected by fire-resistant inner
plates. Remove these inner plates first and then
remove the stove base from the appliance.
Vermiculite inner plates are light and tend to be
ochrous in colour on delivery. They insulate the
combustion chamber to boost combustion.
7 8
inner plate front left
inner plate left rear
inner plate at rear
inner plate front right
inner plate right rear
inner plate top
baffle plate
baffle plate holder
7
6
3
5
4
09-20020-308
9