Product Presentation; Reminders And Recommendations; Mounting Kit - CDVI SOLARMWD Mode D'emploi

INSTALLATION MANUAL
SOLARMWD - SOLARMBD
13.56Mhz EV1 Desfi re Mifare

1] PRODUCT PRESENTATION

Wiegand 26, 30 or 44 bit.
Desfi re EV1 (Tag 2 to 8 K).
Direct connection or with the door controller
(INTBUSW).
PCB sealed in epoxy.
Audible and visual feedback.
3m pigtail wire connection.
Tamper switch.
Versions available: white or black.
Cryptage AES 128.
Dimensions (L x W x D) : 130 x 90 x 28mm.
Technology: 13.56Mhz.
Input voltage: 12V dc.
Consumption: 220mA.
CE Certifi cation
Certifi cation FCC CFR 47
WEEE
part 15 compliance

2] REMINDERS AND RECOMMENDATIONS

Important
To protect the device from
back-emf, do not forget to
install the varistor across the
lock terminals, in parallel.
Suggested power supplies
ARD12 & BS60 (in case the
reader is powered neither
by the controller nor by the
reader controller INTBUSW).
These products must
powered in 12Vdc and the
power supply should
certifi ed EN60950-1:2006/

3] MOUNTING KIT

Foam seal
SOLARMWD
SOLARMBD
2
cdvigroup.com
Reader - Wiegand
®
-25°C to +70°C
IP53
A11:2009 standards
should be designed to be a
low power supply source.
Recommended cables
4 twisted pairs 0.6mm (AWG 24).
This product is supplied
with a varistor.
The varistor
connected directly to the
be locking system
(electric strikes,
be magnet, or lock) operated
by the device. If the device
3x30
TF screw
1 2
35
and functions with several locking
systems, each one must
be fi tted with a varistor.
The varistor limits overload
produced by the strike coil,
known as
back-emf. If you are using
a "Shear Lock", electromagnet
or other type of electric lock,
must be we recommend the use of
a dedicated power supply
terminals for the lock.
electro-
S5 Plastic
Torx
®
anchor
2 1
90
self-effect or
illumination,
the product.
3x8
bit
Torx screw
®
1
EN
For optimal
do not fold
the cable
inside
Varistor
1