CDVI SOLARMWD Mode D'emploi page 3

INSTALLATION MANUAL
SOLARMWD - SOLARMBD
13.56Mhz EV1 Desfi re Mifare
4] MOUNTING
Make sure that there are no pieces missing from the mounting kit. Use the correct tools according to the
installation (drill, screwdrivers, tape measure,...) and follow the mounting instructions of the reader.
1
1 Measure and mark the center lines to determine the
reader position. Drill the fi xing screw holes (Diameter:
5mm). Drill the wiring access area (Diameter:
15mm).
3
3 Insert the plastic plugs in the mounting holes, connect the cable (refer to wiring diagram on page 11), then fasten
the reader with the TORX
the lock (refer to page 8 "Reminders and recommendations").
Reader - Wiegand
®
2
screw using the TORX
® ®
Foam seal
Sch. a
2 Place the foam seal at the back of the reader. Take
care to begin from the bottom. (Sch. a). The foam
seal must be visible (about 2mm) on the top-back
of the reader (Sch. b).
bit (Sch. c). Make sure that the varistor is connected across
EN
Sch. b
Sch. c
3
cdvigroup.com