Environmental Protection - Ryobi CDA1802 Manuel D'utilisation

page de 129

/ 129
Matières
Table des Matières
Signets

Table des Matières

OPERATION

NOTE: This drill has an electric brake. When the

switch trigger is released, the chuck stops turning.

When the brake is functioning properly, sparks will be

visible through the vent slots on the housing. This is

normal and is the action of the brake.

WOOD DRILLING

For maximum performance, use high speed steel bits for

wood drilling.

■

Begin drilling at a very low speed to prevent the bit

from slipping off the starting point. Increase the speed

as the drill bit bites into the material.

When drilling through holes, place a block of wood

■

behind the workpiece to prevent ragged or splintered

edges on the back side of the hole.

■

When drilling large holes in wood with spade bit, the

Max admitted bit size is 38mm.

METAL DRILLING

For maximum performance, use high speed steel bits for

metal or steel drilling.

■

Begin drilling at a very low speed to prevent the bit

from slipping off the starting point.

■

Maintain a speed and pressure which allows cutting

without overheating the bit. Applying too much

pressure will:

• Overheat the drill;

• Wear the bearings;

• Bend or burn bits; and

• Produce off-center or irregular-shaped holes.

■

When drilling large holes in metal, start with a small

bit, then finish with a larger bit. Also, lubricate the bit

with oil to improve drilling action and increase bit life.

MAINTENANCE

WARNING:

When ser vicing, use only identical Ryobi

replacement parts. Use of any other parts may

create a hazard or cause product damage.

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use.

Use clean cloths to remove dirt, dust, oil, grease, etc.

WARNING

Do not at any time let brake fluids, gasoline,

petroleum based products, penetrating oils, etc.,

come in contact with plastic parts. Chemicals can

damage, weaken or destroy plastic which may

English

result in serious personal injury.

Do not abuse power tools. Abusive practices can damage

tool as well as workpiece.

WARNING

Do not attempt to modify this tool or create

accessories not recommended for use with this

tool. Any such alteration or modification is misuse

and could result in a hazardous condition leading

to possible serious personal injury.