The First Cycle; Extra Programmes - Pelgrim GVW855 Notice D'utilisation

The first cycle

(see fig. 2a/2b)
Turn the tap on fully .
Open the door. The control buttons and the
display can now be seen.
If no programme has been selected, "PO"
appears on the display.
Press the programme selection button. The
last selected programme appears on the
display. Pressing the button repeatedly causes
the other programmes to appear on the display
one after the other (see the programme
selection table on pages 27 and 28).
When you press a button, you will hear an
audible signal. If you do not hear an audible
signal, then either the function concerned is
not available or the audible signal has been
switched off (see "Personal preferences").
Close the door and the programme will start
automatically.
End of programme
The dishwasher switches itself off
automatically when the programme has
finished. An audible signal indicates when a
programme has finished. "PO" appears on the
display.
The dishwasher can be switched off manually
by keeping the programme selection button
pressed for about three seconds until "PO"
appears on the display. Then close the door.
Unload the dishwasher. Be careful:
– The kitchenware could be hot.
– Unload the lower basket first. If you unload
the upper basket first, drops of water could
fall on the kitchenware in the lower basket.
Interruption in a running program
Open the door carefully, so that there is no
water squirting out of the machine.
When the water is already heated up, close
the door completely only after some minutes
resting in leaned position. Add eventually
extra loading. Caution:
– the tablewear inside can be very hot.

Extra programmes

(if available)
Delaying the start time
The time at which a programme starts can be
delayed for a minimum of one hour and a
maximum of nine hours.
After switching the appliance on, you can set
the start time you want with the
The time remaining until the programme
starts is shown on the display. The time
display will disappear if you do not touch a
button for five seconds or if you press
another button. Press the
display the time remaining.
Economy programmes
E button
You can decrease the temperature of
programmes 4 to 8 by means of the E button. This
provides considerable savings in energy
consumption. The duration of the programme is
also shortened.
button.
button once to