Pelgrim GVW855 Notice D'utilisation page 43

Note:
Allow for possible differences in the thickness
of the panel (milled hollows or bevelled
edges).
Fix the mounting material to the door, as
indicated on the template.
Attach the panel to the door of the
dishwasher by pressing the upper pins
(fig. 18a) into the slots of the plastic section.
Slide the panel up a little. Screw the panel
tight from the inside, as shown in figure 18b.
Adjusting the spring tension (see fig. 19)
As standard setting, the door is adjusted to
the lowest spring tension.
fig. 18a
Increase the tension of the spring by
turning the two adjusting screws in a
clockwise direction with a screwdriver.
The tension of the spring is correct if the
door is in a state of equilibrium when open.
Positioning (see fig. 20)
fig. 18b
Note:
You should not allow the hoses to develop
kinks or get flattened during the installation of
the dishwasher in the recess.
fig. 19
fig. 20