Pelgrim GVW855 Notice D'utilisation page 34

The means of operation will depend on the
type of dishwasher: the containers all work
on the basis of the same principle.
Unscrew the lid of the rinse-aid reservoir in
an anti-clockwise direction.
Pour rinse-aid into the container and then
close it again.
The container has a capacity of 140 cc.
Every now and again check the level of the
rinse-aid. The level gauge (A) is located to
the upper left of the lid.
Reservoir empty: .
!
Reservoir full: .
c
Top up the rinse aid if the rinse-aid
indicator symbol on the information display
lights up.
The correct quantity of rinse-aid per
washing cycle is adjustable.
Turn the knob (B) in the container to the
desired setting (C). The amount of rinse-aid
is in proportion to the numbers on the knob.
– Increase the amount (choose a higher
number):
Washed kitchenware is dull or flecked as
a result of dried drops of water.
– Reduce the amount (choose a lower
number):
Washed kitchenware is sticky or has
whitish streaks.
Remark:
As standard, the rinse-aid reservoir is set to
an average dose.
Detergent
A
In the door, next to the rinsing agent reservoir,
there is also a reservoir for the detergent
(see fig. 6).
Open the lid of the reservoir by pressing
button (A).
Fill the reservoir (B) with approx. 25
grammes of detergent.
Follow the detergent manufacturer's
guidelines.
If you select the "super" programme, please
take the following steps:
Fill the reservoir with approximately
20 grammes of detergent, and fill the pre-
wash detergent reservoir (C) with
approximately 10 grammes of detergent.
Close the lid.
Remark:
The container lid is opened automatically
during the washing cycle in order to add the
detergent to the water. If washing tablets are
used – in a holder attached to the cutlery
basket – the container should be closed.
B C
fig. 6