HP Designjet 130 Guide De Référence Rapide page 21

HP Designjet 130/130nr Printer - Quick Reference Guide
How Do I Replace the Printheads? (continued)
...continued from previous page...
6. Finally close the rear part and then the front part of the outer flap. Note that
after closing the flap, the printer will automatically perform some internal
calibrations on the printhead, and then alignment. There must be paper in
the tray during alignment (you can use your least expensive paper). Pre-
alignment calibrations may take some time, especially if multiple printheads
are replaced.
7. Check that the printhead icon on the front panel is no longer flashing. The
printhead has been replaced successfully.
Perform a color calibration, as described in "How Do I Perform a Color
Calibration?" on page 3.
For more detailed instructions for replacing a printhead, see the topic How do I
replace printheads? on the Using Your Printer CD.
19