Metal Cutting - Skil JS820301 Guide D'utilisation

Metal Cutting

WARNING
Clamp the material when cutting metal.
•
Be sure to move the saw along slowly.
•
Use lower speeds.
•
Do not twist, bend, or force the blade.
•
If the saw jumps or bounces, use a blade with finer teeth.
•
If the blade seems clogged when cutting soft metal, use a blade with coarser teeth.
•
For easier cutting, lubricate the blade with a stick of cutting wax, if available, or with cutting
•
oil when cutting steel.
Thin metal should be sandwiched between two pieces of wood or tightly clamped onto a
•
single piece of wood (wood on top of the metal). Draw the cut lines or design on the upper
piece of wood.
When cutting aluminum extrusion or angle iron, clamp the work in a bench vise and saw
•
close to the vise jaws.
When sawing tubing and the diameter is larger than the blade is deep, cut through the wall
•
of the tubing and then insert the blade into the cut, rotating the tube as you saw.
18
Never use the wood-cutting blade for cutting metals. Failure to do so
could result in serious personal injury.