Led Light - Skil JS820301 Guide D'utilisation

Dust-Blowing Slide Switch (Fig. 7)
Your tool is equipped with the dust-blowing
function to blow away the dust while cutting for
better visibility.
To blow the sawdust, slide the switch to the
blowing setting 1.
To turn off the blowing function, slide the switch
to setting 0.

LED Light

Your tool is equipped with an LED light, located
on the front of the tool. This provides additional
light on the surface of the work piece for
operation in lower-light areas.
The LED light will automatically turn on with a
slight squeeze on the variable-speed trigger
switch before the tool starts running. It will turn
off 8 to 12 seconds after the variable-speed
trigger switch is released.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
are overloaded, the LED light will rapidly flash.
Rest the tool for a while or place the tool and
battery pack separately under air flow to cool.
The LED light will flash more slowly to indicate that the battery charge is low. Recharge the
battery pack.
Fig. 7
Fig. 8
15