SilverCrest SBTF 10 C2 Mode D'emploi page 49

Replacing the fuse
The hands-free set is equipped with a fuse. If the device
no longer works, check the fuse and replace if necessary.
GB
●
Open the vehicle connector plug 1 by turning the
fl uted screw insert
if necessary – and remove it.
●
Remove the plug tip
out. Ensure that the spring
plug 1 does not accidentally jump out and become lost.
●
Place a new fuse of type F2AL/250V into the vehicle
connector plug 1, place the plug tip
of the fuse that is slightly protruding
screw insert that you removed earlier
Risk of fi re!
●
Replace the fuse only with another of the same rating
as that given on the ratings plate. Fuses with a diff erent
rating may cause fi re. Smoke resulting from such a fi re
is poisonous.
Note:
If these measures do not correct the problem, please con-
tact the appropriate service partner for your country.
46
D
gently anticlockwise – with pliers
A
from the fuse
B
in the vehicle connector
D
C B A
and pull the fuse
C
onto the end
B
and screw the
C
back in.
A
SBTF 10 C2