CARE INTENSIVE LINE Mode D'emploi page 11

Sleep Mode：
When the console in the standby mode, if RPM is lower than 30 or keys no operation for 15 seconds, the
program will enter the prompt mode for 16 seconds (after 16 beeps the scale enters sleep mode). During the
timing period of 16 seconds, if RPM is higher than 30 or keys are pressed, the timing program of 16 seconds
will be canceled, and the console will go back to standby mode.
In the setting page (User setting, weight setting and settings in all programs), if RPM is lower than 30 for 10
seconds, the program will be end and jump back to standby mode. If RPM is still lower than 30 or no key
operation is detected after 5 seconds, the program will enter prompt for 16 seconds (after 16 beeps the scale
enters sleep mode). During the timing period of 16 seconds, if RPM is higher than 30 or keys are pressed, the
timing program of 16 seconds will be canceled, and the console will go back to standby mode.
When operating all the programs, if RPM has not been reached to 30, dot matrix display will show the rolling
string of "RPM↑" for 5 seconds. After that, if the RPM still not reached to 30, dot matrix display will show the
rolling string of "PAUSE" for 5 seconds.
III. Key instruction
：
1.START
Press the key (START), and the program will start the function of QUICK START directly.
：
2.RECOVERY
During the exercise, hold the hand pulse sensor until the PULSE window shows the heart rate value, and then
press RECOVERY. After press RECOVERY, the displays will stop and the TIME window will show count
down for 60 seconds. After the time count down to 0, will display will show the result of your heart rate
recovery status with F1~F6. F1 means the best level of the heart rate recovery status.
：
3.PAUSE
After the start the exercise, press PAUSE key, and the program will immediately operate the action of
"pause".
During the setting process within PROGRAM, press PAUSE key could go back to the program select page for
reworking.
：
4.STOP
Press STOP key to stop. And can use ENTER key to switch the display "SPEED - TIME – DISTANCE / RPM -
CALIROES - WATTS" screen.
：
5.ENTER
During the setting of programs, press ENTER key to confirm and go to the next page.
：
6.DIRECTION , , , , ,