IKRA HESI 750 Manuel D'utilisation page 22

b) Then saw from top to bottom to the first cut using the
bottom side of the guide bar.
c) Saw off longer branches in sections in order to
maintain control over the location of impact.
Kickback
The term kickback refers to when the chainsaw suddenly
jumps up and back. This is usually caused by the work-
piece coming into contact with the guide bar tip or the
clamping of the saw chain.
A kickback generates abrupt, powerful forces. Therefore,
the chainsaw usually reacts in an uncontrolled manner.
The consequence is often the severe injury of the user
or nearby persons.
The danger of a kickback is greatest if you apply the area
near the guide bar tip to a branch, because the leverage
effect is greatest there. Therefore, always apply the saw
as flatly as possible.
Attention!
• Always make sure that the chain tension is correct!
• Only use properly functioning chainsaws!
• Only work with a saw chain sharpened according to
regulations!
• Never saw with the upper edge or tip of the guide bar!
• Always hold the chainsaw firmly with two hands!
Sawing wood under tension
Sawing wood which is under tension necessitates ele-
vated caution! Wood that is under tension and is then
released from that tension when cut occasionally reacts
in a completely uncontrolled manner. This can result in
severe to deadly injuries. Such work may only be perfor-
med by trained specialists.
GB | Operating Instructions
7