Fermax DUOX Manuel D'installation page 28

COD.: 97731 V02/14
This tool allows you to perform programming tasks and search for incidents in installations
with the DUOX system by FERMAX.
It has 2 operating modes:
CONSOLE MODE
This allows for the programming and programming status check of the DUOX system
d e v i c e s , w h e t h e r
In the latter, the DUOX programmer must provide power via its USB port.
INSTALLATION ANALYSER MODE
This allows for the analysis of incidents (analysis of commands, data frames and their level
of tension) and verify the components in a specific, already running installation.
This is powered by the installation itself.
DESCRIPTION
1
2
3
4
1. Alphanumerical Display
2. Numerical Keypad
3. Escape key to go back a step in
programming
4. Connection key
5. Forward and back keys
6. Confirmation key
DUOX PROGRAMMER REF. 3254
i n t h e i n s t a l l a t i o n
1 2 3
6
4 5 6
7 8 9
7
0
ESC OK
ON
OFF
8
5
i t s e l f o r
9
10
7. Connector for coiled cable of the
telephone to be programmed.
8. USB connector for the programmers
power supply in CONSOLE mode.
9. 3 way connector for connecting to the
BUS DUOX (use both end pins),
10.6 way connector (to connect to the
amplifier to program in CONSOLE
mode).
a t t h e w o r k s h o p .