Specific Operation - SOMFY CONTROL BOX 3S io Manuel D'utilisation

Control Box 3S io
Stop (Fig. 8)
General closing (Fig. 10)
Movement not performed (Fig. 12)
Obstacle detection operation
When an obstacle is detected during opening, the gate will stop and partially reverse.
When an obstacle is detected during closing, the gate will stop and reopen.

Specific operation

Depending on the peripherals installed and the operating options programmed by your installer, the motor may have the following specific functions:
Operation with a Situo io, Telis io or Composio io type remote control (Fig. 13)
Operation with safety cells
An obstacle placed between the cells will prevent the gate from closing.
if an obstacle is detected when the gate is closing, it stops then reopens fully or partially depending on how it was programmed during installation.
If the cells are obscured for 3 minutes, the system switches to the "wired deadman operation" mode. In this mode, a command via a wired input causes
the gate to move slowly. The gate moves for as long as the command is issued and stops immediately when the command is discontinued. The system
switches back to normal operating mode as soon as the cells are no longer obscured.
N.B. the "wired deadman" mode requires the use of a safety contact (e.g. keyed reversing switch ref. 1841036).
5
8
STOP
10
General stop (Fig. 9)
Movement interrupted (Fig. 11)
12
13
STOP
9
STOP
11
STOP
Copyright © 2011 Somfy SAS. All rights reserved