Bodum IBIS 5500 Mode D'emploi page 11

– Remove the appliance body from the base unit (4).
– Open the lid (1), fill with water and close the lid again.
Do not fill the kettle with less than 0,25l/17oz and not more
than 1,7l/57oz (above the MAX mark), to prevent the kettle
from boiling dry or boiling water escaping from the spout.
CONNECTION TO POWER SUPPLY
– After filling the kettle, position it on the base unit (4).
Ensure that the kettle body is seated correctly on the
contact unit on the base unit (4).
– Connect the mains plug to the power supply and press
down the ON/OFF switch (3).
Note: Ensure that the ON/OFF switch is able to move freely.
SWITCHING OFF
– Your kettle has an automatic ON/OFF switch and will
switch itself off automatically as soon as the water boils.
– You can switch off the kettle at any time by raising the
ON/OFF switch (3).
Note: The kettle cannot be switched off by hand if the
switch is not free to move, or if the ON/OFF switch is pressed
down.
POURING OUT WATER
– To remove the kettle from the base unit (4), hold it by its
handle. Ensure that the kettle body remains level while
lifting it from the base unit (4).
– Pour the water from the spout with the lid (1) closed.
Note: Please take care when pouring out water as boiling
water can cause scalds.
SWITCHING THE KETTLE ON AGAIN
– If the kettle was switched off by hand, it can be switched
on again at any time.
– You may switch the kettle on again as soon as the built-
in thermal safety cut-off switch has had sufficient time
to cool.
9