Connecting To A Wireless Network; Network Type; Advanced Mode - Telefunken H42S5 Mode D'emploi

Connecting to a Wireless Network

To make your modem's SSID visible, you should
change your SSID settings via modem's software.
The TV cannot connect to the networks with hidden
SSID.
For connecting to a wireless LAN network, you
should perform the following steps:
1. Connect broadband ISP connection ethernet
cable to the ETHERNET INPUT of your
modem.
2. Ensure that Nero Media Home software is
installed to your PC (for DLNA function).
3.
Network Settings section in the following
sections.
simultaneous 2.4 and 5 GHz bands designed to
increase bandwidth. Optimized for smoother and
faster HD video streaming, file transfers, and
wireless gaming.
other devices like computers.
The frequency and channel differ depending on the area.
The transmission speed differs depending on the
distance and number of obstructions between the
and the products that you use. The transmission
may also be cut off or get disconnected depending
on the radio wave conditions DECT phones, or any
other WiFi 11b appliances. The standard values of
the transmission speed are the theoretical maximum
values for the wireless standards. They are not the
actual speeds of data transmission.
The location where the transmission is most effective
differs depending on the usage environment.
extension cable In cases where network quality is poor
with better signal quality.
n type modems. It is highly recommended that you
in order to avoid any possible problems while
watching videos.
Use the other usb input, if you experience problems
with audio/video performance.
You must change your modem's SSID when there
are any other modems around with the same SSID.
If you are connecting the TV via ETHERNET INPUT,
select Network Type as Wired Device

Network Type

Network type can be selected as Wired or Wireless
device, in accordance with the active connection to the
TV set. Select this as Wired if you have connected to the
TV a LAN cable. Select as Wireless if you connect via
the wireless USB dongle.
This section displays the status of the connection.
IP Address
If an active connection is available, the IP address will
address preferences, press GREEN button and switch
to the advanced mode.

Advanced Mode

While in Advanced Mode, press RED button to edit
settings. When finished, press OK to save, Press
RETURN/BACK to cancel.
Wi-Fi feature can be used for a wireless network
connection.
properly.
Press YELLOW button to scan wireless network.
Afterwards, available network list will be displayed.
Please select your desired network from the list.
If the selected network is protected with a password,
please enter the correct key by using the virtual
keyboard. You can use this keyboard via navigation
buttons and OK button on the remote control.
Wait until the IP the address is shown on the screen.
This means that the connection is now established. To
disconnect from a wireless network, you should highlight
English
and press OK.