Acoustic Signals - AEG FAVORIT 88070 VI1P Notice D'utilisation

26 www.aeg.com
5.3 Multitab
Activate this option only when you use
the combi detergent tablets.
This option deactivates the use of rinse
aid and salt. The related indicators stay
off.
The programme duration can increase.
How to activate the Multitab option
1. Press the on/off button to activate
the appliance.
2. Press Multitab, the related indicator
comes on.
The option stays on until you deactivate
it. Press Multitab, the related indicator
goes off.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Deactivate the Multitab option.
CAUTION!
Do not try to close the appliance
door while the device keeps the
door ajar. This can cause dam-
age to the appliance.
If you want to deactivate the AutoOpen
option, press AutoOpen. The related in-
dicator goes off.
In this condition, the energy consump-
tion of the programme increases.

5.5 Acoustic signals

The acoustic signals operate when the
appliance has a malfunction, when the
adjustment of the level of the water soft-
ener occurs and when the programme is
completed.
By default, the acoustic signals are on,
but it is possible to deactivate them.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the released quantity of rinse
aid.
5.4 AutoOpen
This option gives good drying results
with less energy consumption.
This option is automatically activated
when you set the programme
AutoOpen indicator comes on.
It is not possible to set this option with
other programmes.
• While the drying phase operates, a
device opens the appliance door and
keeps it ajar.
• At the end of the programme, the de-
vice and the appliance door retract.
The appliance automatically deacti-
vates.
How to deactivate the acoustic signals
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
2. Press and hold, at the same time,
Program and ExtraHygiene until the
indicators of Delay, Program, Extra-
Hygiene and TimeSaver start to flash.
3. Press ExtraHygiene.
• The indicators of Delay, Program
and TimeSaver go off.
• The indicator of ExtraHygiene con-
tinues to flash.
• The display shows the current set-
ting.
Acoustic signal on.
Acoustic signal off.
. The