Filling The Rinse Aid Dispenser; Daily Use - AEG FAVORIT 88070 VI1P Notice D'utilisation

6.2 Filling the salt container

6.3 Filling the rinse aid dispenser

7. DAILY USE

1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
A B
A
+ -
C
D
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt con-
tainer (only for the first time).
3. Fill the salt container with dishwash-
er salt.
4. Remove the salt around the opening
of the salt container.
5. Turn the cap clockwise to close the
salt container.
CAUTION!
Water and salt can come out
from the salt container when you
fill it. Risk of corrosion. To pre-
vent it, after you fill the salt con-
tainer, start a programme.
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between
position 1 (lowest quantity) and
position 4 (highest quantity).
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree
of soil.
ENGLISH
29