Acoustic Signals - AEG FAVORIT 55522WO Notice D'utilisation

28 www.aeg.com
3. Press Program again and again to
change the setting.
4. Press the on/off button to confirm
the setting.
6.3 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
How to use rinse aid and multi-
tablets together
By default when you activate the option
Multitab, the rinse aid dispenser no
longer releases rinse aid. However if you
are using multi-tablets and the drying
results are not satisfactory, we suggest to
use multi-tablets and rinse aid together.
In this case you have to activate the rinse
aid dispenser.
The rinse aid dispenser will remain
activated until you modify the setting
again
How to activate the rinse aid
dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold simultaneously Delay and Start
until the indicators
and the display is blank.
2. Press Option.
• The indicators
off.
• The indicator
flash.
• The display shows the current setting.
–
deactivated.
All manuals and user guides at all-guides.com
,
and start to flash
and
continues to
= rinse aid dispenser
– = rinse aid dispenser
activated.
3. Press Option to change the setting.
4. Press the on/off button to confirm
the setting.
5. Adjust the dosage of rinse aid.
6. Fill the rinse aid dispenser.

6.4 Acoustic signals

Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode press and
hold simultaneously Delay and Start
until the indicators
and the display is blank.
2. Press Delay
• The indicators
go off.
• The indicator
flash.
• The display shows the current setting:
– = Acoustic signal off.
go
– = Acoustic signal on.
3. Press Delay to change the setting.
4. Press the on/off button to confirm
the setting.
,
and start to flash
and
continues to