Using The Cooler - Dometic CDF Série Notice D'utilisation

CoolFreeze
7.5

Using the cooler

A
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
➤ Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
➤ Close the cooler, see chapter "Connecting the cooler" on page 13.
A
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
Locking the cooler
➤ Close the lid.
➤ Press the lock (fig. 6 1, page 4) down, until it latches in place audibly.
CDF18: Switching on the cooler
➤ Slide the sliding switch "BATTERY MONITOR" to HIGH if you wish to operate
from a starter battery or to "LOW" if you want to operate from a supply battery.
✓ The "POWER" LED is lit green.
✓ The cooler starts cooling the interior.
➤ Set the cooling temperature with the temperature controller "TEMPERATURE".
✓ When the cooling temperature has been reached, the "POWER" LED is lit yellow.
CDF26, CDF36, CDF46: Switching on the cooler
➤ Press the "ON/OFF" button for three seconds.
✓ The "POWER" LED is lit green.
✓ The display switches on and shows the current cooling temperature.
✓ The cooler starts cooling the interior.
EN
Operation
15