Water Connections; Water Discharge; Steam Feeding; Steam Discharge - Whirlpool AGB 788/WP Manuel D'emploi

MANUAL FOR USE
GB

WATER CONNECTIONS

IMPORTANT
The machine has a filter whose inlet, install a maintenance and safety valve in an easily
accesible position upstream. The water temperature should be between 50°and 55°C;
the pressure should be between 1.5 and 3 bar (150/300 Kpa);and the water hardness
should be between 7° and 12° French.
Hold down the button located next to the thermostat and fill the boiler with water. When
the boiler is completely full, water will issue from the rinsing nozzles. Now set the ther-
mostat to 90°C.
Be careful here, because if you let it get to high,you couldburn out the electrical.
With machines that have a prewash function, a steam-condenser and heat energy-reco-
very capability, cold water must be fedin at a temperature of between 10° and 15°C.

WATER DISCHARGE

Install a floor-level discharging siphon connected to the discharge drain. If no siphon is
provided, install one soas to avoid fumes. Make sure that the discharge tube can resist
a temperature of 70°C and no kinks in it.

STEAM FEEDING

Connect to the machine fittings as shown in the installation drawing. Install quick-clo-
sing and shit-off valves to make the equipment independent from the main line. The
steam should be supplied, saturated and dry, at presures ranging between a minimum
of 0.5 bar (50Kpa-110.8°C) and a maximum of 0.8 bar (80Kpa-110.8°C)

STEAM DISCHARGE

The condesed steam discharge line to the recovery system has to have an adequate
slope to provide positive evacuation. Install a recycling pump if required.
This is only for steamheated machine. A maintenance quickclosing valve should be
installed in parallel with the condensate discharge, so as to be able to deviate the con-
densate to the sewer.
25