Mains Connection - Whirlpool AGB 788/WP Manuel D'emploi

MANUAL FOR USE
GB
INSTALLATION NORMS
The terminals (B) and (D) on the terminal strip are for the doser connections: (B) for the
brightener and (D) for the detergent.
Do not pour detergent directly into the tubs; this will cause dark marks to appear on their
surfaces. Only use anti-foaming detergent.
The brightening equipment (B) operates on 24V, and the detergent aquipment (D) ope-
rates on the mains voltage. The machine equipped with a IPX4 degree of protection and
should therefore not be washed using direct jets of water.

MAINS CONNECTION

Remove the electrical box cover and connect the electrical cord leads to terminals
L1,L2,L3. The mains power characteristics must be compatible with the data shown on
the machine's data plate. A wall-mounted switch must be installed, and it must also
have a "breaker solenoid". This solenoid must be connected to the A terminals in the
electrical box. The electrical system's emergecy provision (emergency head) must be
inspected and checked at least every six months to see that it is operating properly.
In order to use the correct main swith on the wall is given in the enclosed table, and is
to be selected according to the voltage, the particular machine model and type of hea-
ting (electrical or steam). Check the length of the electrical line. If it is too long, adapt its
cross-section to the power draw; do not put any tension in the electrical cord.
In compliance with the existing norms regarding electrical safety, see that the equip-
ment is connected to a proper grounding system.
In compliance with the existing norms, check to see that the equipment is included in
an equipotential system. Make the connection using the screw marked with the special
tag, whichis located behind the electrical box.
Check to see that the motor turns in the direction shown by the arrow. If it does not do
this, invert the two phase lines. The manufacture declines any responsability for any
damage caused by the lack of an efficient grounding system.
IMPORTANT:
Before removing the electric equipment's protective cover, make sure the current
to the Wall-mounted main switch is turned off. Unqualified personnel may not
access electrical equipment.
24