Delta 17-959L Manuel D'utilisation page 12

INSTALLING THE CHUCK
IMPORTANT: Make certain that the tapered hole in the
bottom of the spindle (T) Fig. 17, and the taper on the
spindle adapter (U) are clean and free of grease, lacquer,
or rust-preventive coatings.
NOTE: Household oven cleaner can effectively remove
these coatings from the spindle and spindle adapter.
However, carefully follow the manufacturer's safety rules
regarding its use.
Push the spindle adapter (U) Fig. 17 into the spindle (T).
making certain that the tang (V) engages the mating slot
inside the spindle (T).
RISK OF PROPERTY DAMAGE. To avoid damage to the laser, prevent the cleaning solution from
coming in contact with the laser pod. You can clean the laser pod with a dry cotton cloth.
IMPORTANT: Make certain the spindle taper (O) Fig. 18,
and tapered hole in chuck (P) are clean and free of any
grease, lacquer, or rust preventive coatings.
NOTE: Household oven cleaner can effectively remove
any substance from the chuck. However, carefully follow
the manufacturer's safety rules concerning its use.
IMPORTANT: Open the chuck jaws as wide as possible,
making sure that the chuck jaws are inside the chuck.
Hold the chuck on the taper of the spindle. Tap it with
a soft-tip hammer (Q) Fig. 19 or a block of wood and
hammer to set the chuck.
RISK OF PROPERTY DAMAGE. To avoid damage to the chuck, NEVER drive the chuck on the
spindle with a metal hammer.
ATTACHING THE PINION SHAFT HANDLES
Thread the three pinion shaft handles (R) in the three
holes located in the pinion shaft hub (S) Fig. 20.
V
Fig. 17
Fig. 18
Fig. 19
12
T
U
O
P
Q
R
S
Fig. 20