Delta 17-959L Manuel D'utilisation page 10

RISK OF UNSAFE OPERATION. You must secure the plywood base to the floor or supporting
surface if the drill press has any tendency to vibrate, slide, or walk during normal operation.
6. Attach the column (A) Fig. 4 to the base (B) using the four M10 x 40mm hex head screws (C), three of which are
shown.
7. Attach the table adjusting handle (D) Fig. 5 to the worm gear shaft (E). Tighten the screw (F) against the flat on the
shaft with the 3mm wrench supplied.
8. Thread the table clamp handle (G) Fig. 6 in the hole in rear of table bracket.
A
C
B
9. Attach the levers to the underside of the table by turning the screw in the lever clockwise (Fig. 7).
10. Remove both entire lever assemblies (A) Fig. 7 by turning them counter-clockwise. Remove the washers.
11. Lift the table support (B) Fig. 8 from the table (C).
12. Place the flat washer (D) Fig. 9 with the raised side against the 12mm bolt (E).
13. Insert the bolt into the table support, then into the hole in the knuckle (G) Fig. 10. Tighten securely.
14. Align the bolts (H) in the trunnion (J) with the holes in the table support (K).
15. Replace the washers and lever assemblies that were removed in STEP 10. Tighten securely.
NOTE: The bolts in the trunnion are moveable. To make the replacing of the levers easier, insert a fl athead screwdriver
(L) Fig. 12 in the opening of the trunnion against the bolts to steady them.
A
C
D
Fig. 4
C
Fig. 7
G
K
Fig. 10
Fig. 11
F
E
Fig. 5
B
Fig. 8
J
H
10
G
Fig. 6
E D
Fig. 9
L
G
Fig. 12