Start; Refuel; Throttle Control - Zipper Maschinen ZI-MOS145G Mode D'emploi

14.1.5 Start

Assure yourself prior to every start that the fuel-oil
mixture is shook up well. Do not use self –mixed
mixtures older than one month.
Check all machine parts for condition and all
connections for tight set.
Put the main switch G into position I.
Apply the choker by putting lever J into upper position.
The choker is used for starting the machine when it is cold.
Then press 2-3 times the primer pump (28).
You find the primer between fuel tank and carburettor-
bottom.
Now start the engine buy pulling the starter K out briskly.
When the machine has started, shut the choker J off again.
Let the machine run for one minute in idle run.
TO STOP THE MACHINE IT IS ENOUGH TO PUT THE
MAIN SWITCH G INTO POSITON O (=STOP)

14.1.6 Refuel

Use 2-stroke HQ oil. Ask for advice from your local reseller.
ZIPPER Maschinen recommends using ready-mixed high
quality fuel (e.g. ASPEN2). Self-mixed fuel disaggregates
after a certain time.
There is a risk of damaging the motor due to insufficient
lubrication. Ready-mixed fuel never disaggregates even after
long periods of storage.
If you wish to mix your fuel yourself, you can use the mixing
cup L. 40:1
Tighten the cap M well and mix the fuel by shaking the tank.

14.1.7 Throttle control

Press N.
Now you can press throttle lever O.
You can switch into continuous operation by pressing P
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MOS145Gi 42
OPERATION
42