Assembly; Handle Bar Assembly; Drive Unit Assembly; Protection Cover Assembly - Zipper Maschinen ZI-MOS145G Mode D'emploi

13.2

Assembly

Mount the drive unit with second person!
A non-exact assembly between drive unit and pole will cause machine
damage.
Clean all parts coated with anti-corrosion layer with a mild solvent and
then apply a thin layer of oil.

13.2.1 Handle bar assembly




13.2.2 Drive unit assembly





13.2.3 Protection cover assembly

Use the remaining screws, washers and nuts to assemble the protection cover to the pole shaft.
Depending on the operation mode you can choose the positioning of the protection cover! For
trimming place the protection cover closer to the pole end choosing holes T. For mowing/cutting
use position S
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-MOS145Gi 40
Loosen the premounted sscrews of the
handle bar bracket and insert the
handles A and B from the side into the
bracket.
Tighten the handles to the bracket by
tightening the screws.
Mount the drive unit C to the pole with
the 4pcs M5x30 Screws.
Take care that the pole is inserted
vertically into the green bracket!
Take care that the drive unit is
mounted correctly to the pole.
The tank cap must be positioned as
shown in D.
S
N O T E
A
T
A
B
C
D
ASSEMBLY
A
40