Important Safety Instructions - Milwaukee 48-59-1811 Mode D'emploi

IMPORTANT SAFETY INSTRUCTIONS

READ AND UNDERSTAND ALL INSTRUCTIONS.
WARNING
instructions listed below, may result in electric shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
1. SAVE THESE INSTRUCTIONS - THIS MANUAL
CONTAINS IMPORTANT SAFETY AND OPERAT-
ING INSTRUCTIONS FOR THE MILWAUKEE LI-ION
CHARGER CAT. NO. 48-59-1811 AND MILWAUKEE
M 1 2 ™ A N D M 1 8 ™ L I - I O N B AT T E R I E S .
2. BEFORE USING THE BATTERY PACK AND
CHARGER, READ THIS OPERATOR'S MANUAL,
YOUR TOOL OPERATOR'S MANUAL, AND ALL
LABELS ON THE BATTERY PACK, CHARGER
AND TOOL.
3. TO REDUCE THE RISK OF INJU-
CAUTION
RY, CHARGE MILWAUKEE M12™
AND M18™ RECHARGEABLE LI-ION BATTER-
IES ONLY IN MILWAUKEE M12™ AND M18™
LI-ION CHARGERS. Other types of batteries may
burst causing personal injury and damage. Do not
wire a battery pack to a power supply plug or car
cigarette lighter. Batteries will be permanently dis-
abled or damaged.
4. USE MILWAUKEE LI-ION PACKS ONLY ON COM-
PATIBLE MILWAUKEE LI-ION TOOLS. Battery pack
and charger are not compatible with V™-technology
or NiCd systems. Use with other tools may result in
a risk of fire, electric shock or personal injury.
5. AVOID DANGEROUS ENVIRONMENTS. Do not
charge battery pack in rain, snow, damp or wet
locations. Do not use battery pack or charger in the
presence of explosive atmospheres (gaseous fumes,
dust or flammable materials) because sparks may be
generated when inserting or removing battery pack,
possibly causing fire.
6. CHARGE IN A WELL VENTILATED AREA. Do not
block charger vents. Keep them clear to allow proper
ventilation. Maintain a minimum one inch clearance to
all vents. Do not allow smoking or open flames near
a charging battery pack. Vented gases may explode.
7. MAINTAIN CHARGER CORD. When unplugging
charger, pull plug rather than cord to reduce the risk
of damage to the electrical plug and cord. Never
carry charger by its cord. Keep cord from heat, oil
and sharp edges. Make sure cord will not be stepped
on, tripped over or subjected to damage or stress.
Do not use charger with damaged cord or plug.
Have a damaged charger replaced immediately.
8. DO NOT USE AN EXTENSION CORD UNLESS IT IS
ABSOLUTELY NECESSARY. Using the wrong, dam-
aged or improperly wired extension cord could result
in the risk of fire and electrical shock. If an extension
cord must be used, plug the charger into a properly
wired 16 gauge or larger extension cord with pins that
are the same number, size and shape as the pins on
the charger. Make sure that the extension cord is in
good electrical condition.
9. CHARGER IS RATED FOR 120 VOLT AC ONLY. Char-
ger must be plugged into an appropriate receptacle.
10. USE ONLY RECOMMENDED ATTACHMENTS. Use
of an attachment not recommended or sold by the
battery charger or battery pack manufacturer may
result in a risk of fire, electric shock or personal injury.
11. UNPLUG CHARGER when not in use. Remove
battery packs from unplugged chargers.
12. TO REDUCE THE RISK OF ELECTRIC SHOCK,
always unplug charger before cleaning or mainte-
nance. Do not allow water to flow into AC/DC plug.
Use a Ground Fault Circuit Interrupter (GFCI) to
reduce shock hazards.
13. DO NOT BURN OR INCINERATE BATTERY
PACKS. Battery packs may explode, causing per-
sonal injury or damage. Toxic fumes and materials
are created when battery packs are burned.
14. DO NOT CRUSH, DROP, OR DAMAGE battery
pack. Do not use a battery pack or charger that has
received a sharp blow, been dropped, run over, or
damaged in any way (e.g., pierced with a nail, hit
with a hammer, stepped on).
15. DO NOT DISASSEMBLE. Incorrect reassembly
may result in the risk of electric shock, fire or expo-
sure to battery chemicals. If it is damaged, take it to
a MILWAUKEE service facility.
16. BATTERY CHEMICALS CAUSE SERIOUS BURNS.
Never allow contact with skin, eyes, or mouth. If a
damaged battery pack leaks battery chemicals, use
rubber or neoprene gloves to dispose of it. If skin is
exposed to battery fluids, wash with soap and water
and rinse with vinegar. If eyes are exposed to bat-
tery chemicals, immediately flush with water for 20
minutes and seek medical attention. Remove and
dispose of contaminated clothing.
17. DO NOT SHORT CIRCUIT. A short-circuited battery
pack may cause fire, personal injury, and product
damage. A battery pack will short circuit if a metal
object makes a connection between the positive and
negative contacts on the battery pack. Do not place
a battery pack near anything that may cause a short
circuit, such as coins, keys or nails in your pocket.
18. DO NOT ALLOW FLUIDS TO FLOW INTO BATTERY
PACK. Corrosive or conductive fluids, such as seawa-
ter, certain industrial chemicals, and bleach or bleach
containing products, etc., can cause a short circuit.
19. STORE YOUR BATTERY PACK AND CHARGER in
a cool, dry place. Do not store battery pack where tem-
peratures may exceed 120°F (50°C) such as in direct
sunlight, a vehicle or metal building during the summer.
20. ALWAYS USE A SIDE HANDLE when using a
HIGH OUTPUT or HIGH DEMAND battery pack
6.0 Ah or above; the output torque of some tools
may increase. If your drill/driver did not come with
a side handle, visit www. milwaukeetool.com for the
appropriate accessory handle.
SPECIFICATIONS
Cat. No. ............................................... 48-59-1811
Input Volts .............................................120-127 AC
Max Input Amps ...............................................6 AC
Output Volts .................................................. 12 DC
Max Output Amps ........................................ 4.5 DC
Recommended Ambient
Charging Temperature ................... 40°F to 105°F
M18 ™ Li-Ion Battery Packs ........................ 18 V DC
M12™ Li-Ion Battery Packs ........................ 12 V DC
2
Failure to follow all
18 DC
13.5 DC