Bimar OR125-7 Mode D'emploi page 15

USE
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer
or a competent qualified electrician or a person with similar qualifications, in
order to avoid any risk.
The radiator can be adjusted as follows:
-Selector. Turn the relative knob (C) clockwise to select functions: 0= off,
minimum, = medium,
- Room thermostat. Set (using relative knob B) the room temperature and start
the radiator in continuous mode until the set temperature is reached: if these
drops, the radiator restarts for the time necessary to re-establish the set value. If
the knob is turned completely anti-clockwise, the radiator remains off "-", if it is
turned completely clockwise the maximum temperature is set "+"; for
intermediate values the temperature increases as the knob is turned towards the
Maximum position and vice versa.
The lamp is on when the heater is running, if it reaches the set temperature, the
light goes out and turns back on as soon as it decreases.
The radiator has an anti-tipping switch inside which allows it to function only when
the appliance is vertical, and switches it off if it tilts.
Selettore/Type
0
Follow these steps to use the radiator correctly:
1) Insert the plug into the power socket.
2) Turn the thermostat dial (B) to the position of the required temperature.
3) Use the specific switches (C ) to turn on the appliance and to select the
required power:
4) Turn the switches to "0" position to turn off the appliance, and remove the
plug from the power socket.
To switch off the appliance, turn the thermostat knob to minimum/"-", the
5)
selector to "0" and remove the plug from the power socket.
Never leave the appliance connected to the socket if it is not in use, especially
for long periods.
= maximum (for values, see chart below).
HO407 HO409
0W
600W 800W
900W 1200W
1500W 2000W
HO411
0W 0W
1000W
1500W
2500W
15
=