ero electronic ELK Manuel Utilisateur page 41

Mnemonic
OP.LO OUTPUT LOW Limits the minimum heating power applied to the
process or a minimum cooling output.
SAFE SAFE OUTPUT POWER The output power if the loop is in inhibit
The next five parameters apply to current transformer input only. If the CT option is not configured the
LD.AMP LOAD CURRENT is the measured load current when the power
demand is on
LK.AMP LEAK CURRENT is the measured leakage current when the power
demand is off.
LD.ALM LOAD CURRENT THRESHOLD sets a low alarm trip point for the load
current as measured by the CT. This detects partial load failure.
LK.ALM LEAK CURRENT THRESHOLD sets a high alarm trip point for the
leakage current measured by the CT.
HC.ALM OVERCURRENT THRESHOLD sets a high alarm trip point to show over
current as measured by the CT
The next two parameters apply to Digital Communications
ADDR ADDRESS - communications address of the controller, if digital
communications has been supplied. 1 to 254
BAUD BAUD RATE Digital communications baud rate
Part number HA028438. Issue 3.0.
Scrolling Display and description
parameters do not appear
Oct-05
Range
+100% to OP.HI
Default 0% Range +100%
CT Range
CT Range
CT Range
CT Range
CT Range
1 to 254
9600, 19.2K, 4800, 2400,
1200
39