ero electronic ELK Manuel Utilisateur page 36

Mnemonic
SP1 SETPOINT 1 to set the value of control setpoint 1
SP2 SETPOINT 2 to set the value of control setpoint 2
The next four parameters apply to Alarms only. If an alarm is not configured the parameters do not appear
A1.--- - to ALARM 1 (2, 3 or 4) SETPOINT sets the threshold value at which an
A4.--- alarm is detected. Up to four alarms are available and are only shown
if configured.
--- = the mnemonic for the alarm type which may be:-
Lo
Hi
The next two parameters allow current settings to be stored and selected
REC.NO CURRENT RECIPE NUMBER the most frequently used parameters can
be stored in up to 5 recipes. This parameter selects the recipe to use.
STORE RECIPE TO SAVE the most frequently used parameter s can be stored
in up to 5 recipes. This parameter allows you to store the current
values in recipe numbers 1, 2, 3, 4, or 5. none does not store values.
34
Scrolling Display and description
Full Scale Low Bnd
Full Scale High dLo
dHi
Deviation Band
Deviation Low
Deviation High
Part number HA028438. Issue 3.0.
Range
Alterable: from SP.HI to
SP.LO
Alterable: from SP.HI to
SP.LO
SP.HI to SP.LO
none or 1 to 5 or
FaiL if no recipe set
stored
none or 1 to 5
done when stored
Oct-05