Switch On; New Controller - ero electronic ELK Manuel Utilisateur

3.

Switch On

The way in which the controller starts up depends on
factors described below in sections 3.1, 3.2 and 3.3.

3.1. New Controller

If the controller is new AND has not previously been
configured it will start up showing the 'Quick
Configuration' codes. This is a built in tool which
enables you to configure the input type and range, the
output functions and the display format.
!
Incorrect configuration can result in
damage to the process and/or personal injury and
must be carried out by a competent person
authorised to do so. It is the responsibility of the
person commissioning the controller to ensure the
configuration is correct
The quick code consists of two
'SETS' of five characters. The upper
section of the display shows the set
selected, the lower section shows the
five digits which make up the set.
Adjust the quick codes as follows:-.
24
.
1. Press any button
to a flashing '-'.
▲
▼
2. Press or
character to the required code shown in the quick
code tables – see next page. Note: An
indicates that the option is not fitted.
3. Press to scroll to the next character.
☺
You cannot scroll to the next character until the
current character is configured.
☺
To return to the first character press
4. When all five characters have been configured
the display will go to Set 2.
5. When the last digit has been entered press
again, the display will show
▲
▼
6. Press or
then automatically go to the operator level,
section 3.3
Part number HA028438. Issue 3.0.
The first character will change
to change the flashing
x
.
to . The controller will
Oct-05