HQ Power VDP250MHW16 Mode D'emploi page 6

How to turn the controller line from 3-pins to 5-pins (plug and socket):
d. DMX-512 Chain with termination
e. Projector DMX start address selection
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This digital
start address is the channel number from which the device starts to "listen" to the DMX controller. Enter the correct
number and read it from the display located on the base of the VDP250MHW16.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the units will "listen" to the control signal on one particular channel. In
other words: changing the settings of one channel will affect all devices simultaneously. If you set different
addresses, each device will "listen" to a separate channel number. Changing the settings of one channel will only
affect the device in question.
In the case of the 16-channel VDP250MHW16, you will have to set the start address of the first unit to 1, the second
unit to 17 (1 + 16), the third to 33 (17 + 16), and so on.
f. Control Board Operation
FUNCTION TABLE:
Mode
PAN Pan movement in positive or negative direction
Vertical movement in positive or negative direction
TILT
DMX address setting
Addr
Reset
rESET
COLI Rainbow colour wheel change colour linear or stepping
RUN Working mode
Lamp switch
LAMP
Software version
VEr
Lamp hot
HEAT
LA.Er Lamp error
VDP250MHW16
A DMX terminator is recommended for installations where the DMX cable has to run a long
distance or is in an electrically noisy environment (e.g. discos). The terminator prevents
corruption of the digital control signal by electrical noise. The DMX terminator is simply an
XLR plug with a 120 resistor between pins 2 and 3, which is then plugged into the XLR
output socket of the last device in the chain.
Please see illustrations to the left.
Function
6
Condition
YES – negative direction
YES – negative direction
YES - reset
YES - linear
OFF – DMX 512 mode
PR – Automatic
SLAE – Slave mode
ON – Lamp ON
OFF – Lamp OFF
VELLEMAN