Planika Fire Line Automatic 3 Notice D'utilisation page 7

1. To start the configuration, select Wi-Fi CONFIG in the menu. Time to finish the configuration is 5 minutes.
2. Enable Wi-Fi connection in your mobile device and connect to planika123 network (if the network is not visible
on the list, disconnect the power supply from the device for 10 seconds and start the configuration again).
3. Open the browser in your mobile device and enter ' planika.net '. A control panel will appear.
4. Go to SETTINGS . Choose the connection mode ( MODE) and security protocol ( SECURITY ). Enter the network
name ( SSID_NAME ) and password ( PASSWORD ). Accept your settings by pressing submit .
MODE
Blocks wireless control
via Wi-Fi.
SECURITY
SSID_NAME
PASSWORD
5. Connect to the selected/created network in the Wi-Fi menu in your mobile device.
6. Read the IP address ( Device IP ) in the device menu and enter it in the browser in your mobile device. A control
panel will appear.
ERRORS
The errors are accompanied by a sound signal. Press START/STOP to mute or turn the device OFF by pressing
ERROR
TEMPERATURE TOO HIGH
DEVICE HIT
DEVICE TILTED
CO2 LEVEL TOO HIGH
WARNING CLOSE THE LID
CHECK THE TANK WIRE
CONNECTION
ERROR 01
ERROR 05
ERROR 06/16/17/20
ERROR 15
ERROR 21
ERROR
02/03/04/10/16/31/32/41/51/61
FUEL
Use only fuels consisting of
and viscous fuels or fuels of improper electric conductivity. The values must be compliant with those of FANOLA
Other fuels, such as dehydrated ethanol (i.e. consisting of more than 96,6% by volume ethanol) will cause a device
error and loss of the guarantee.
CLEANING –
Clean with a damp cloth and delicate detergents, only when the device is turned off and cooled.
SERVICE –
(keep the provided USB cable for servicing purposes)
WIRELESS CONTROL CONFIGURATION
OFF
Connection with via your local
network and a router
Choose the security protocol used
--
in your local network
(usually WPA/WPA2).
-- Enter the name of your local network.
-- Enter your local network password.
(contact the Service Department if the solution does not eliminate the error)
Ventilate the room to reduce the CO
Disconnect the fuel tank wires and connect them again. (FLA 3 XL)
Fuel spillage has been detected. Turn the device OFF by pressing
and disconnect the pump. Wipe the visible liquid and wait for min. 1 hour.
If the error is not eliminated, wait for min. 24 hours.
The device has been moved. Eliminate the source of shock. Wait for READY .
Turn the device OFF
Turn the device OFF
Turn the device OFF
86-96,6% ethanol by volume. FANOLA
Fuels consisting of 100% by volume ethanol will damage the device.
STA
SOLUTION
Wait for READY .
Do not fill the fuel. Close the fuel inlet lid.
, wait for min. 5 minutes and turn the device ON.
and level the surface on which the device is installed.
and ON. Wait for READY.
Contact the Service Department.
is the recommended fuel. Do not use gel, thick
®
www.planikafires.com/service
7
AP
Direct connection between the
device and your mobile device
(outside your local network)
Choose security protocol WPA
(recommended) or WEP.
Create a network name.
Create a network password
(min. 8 characters).
level. Wait for READY .
2
.
® .