Sleep Function - Planika Fire Line Automatic 3 Notice D'utilisation

When the flame is ignited ( WORKING ), press
height is 4.
ATTENTION! In case the device temperature is too high, the flame will be automatically lowered and the height
regulation blocked. If the temperature keeps increasing, the flame will be extinguished ( COOLING THE DEVICE ,
TEMPERATURE TOO HIGH ).
To extinguish the flame:
- press or
- press STOP In this case, an additional system of fans will be enabled to cool the device faster.
.
Message COOLING THE DEVICE indicates that the device is being cooled. You can ignite the flame again when
the device is cooled – message READY .
To turn the device OFF, press
The device will be turned OFF automatically once any error occurs (see the error table on the next page).
The SLEEP function extinguishes the flame after a set period of time (max. 3 hours).
When the flame is ignited ( WORKING ), press and hold
which the flame will be extinguished and accept with
indicating the time remaining to flame extinguishing.
MENU
The menu is available when messages READY or NO FUEL are displayed. To enter the menu, press and hold
for 8 seconds. Scroll through the settings with
of seconds or press .
SETTING
Device IP View the IP address to configure wireless connection (only if a Wi-Fi network is configured).
WIFI CONFIG Wireless control configuration (see the next page).
MTZ mode External temperature module configuration (read the manual included with the module).
Control panel lock. Enable by pressing
Lock the device
for 5 seconds.
Child lock – flame ignition is initiated by pressing START / STOP for 3 seconds. Choose ON / OFF
Child lock
to enable/disable the function.
Set time
Set the hour by pressing
Programming a new remote or connecting one remote with multiple devices. Press
Remote Control
the configuration. Press and hold START , STOP ,
PROGRAMMING FINISHED informs that the configuration has been successfully completed.
Display off If inactive for 1 minute, the display will turn off. Choose ON / OFF to enable or disable the option.
Faster flame ignition (enabled by default). The power consumption is 100W higher when
Fast start
the device is ready for flame ignition. Choose OFF to disable.
Serial number View the device serial number.
Software View the software version.
History View 40 recent messages.
FLAME HEIGHT REGULATION
+ –
or to make the flame higher or lower in 6 levels. The default flame
FLAME EXTINGUISHING
TURNING THE DEVICE OFF
.

SLEEP FUNCTION

+
–
. A timer will appear in the right upper corner of the display,
+
and accept by pressing
+
, next press
–
and for 10 seconds. Then, press
–
. To quit the menu, wait for couple
DESCRIPTION
–
in the menu. To disable, press and hold START / STOP
–
and set minutes. Accept with
+ –
, for 1 second, respectively. Message
6
+
to set the time after
+
–
.
–
to start