ViewSonic VPAD10 Guide De L'utilisateur page 39

6. Wireless Network Breaks after 2 to 3 Minutes on line, and cannot resume on-line.
This may be due to interference caused by channel, please change the AP's channel and re-line.
7. VPAD10 cannot connect to the Internet Network.
Internet service providers (ISP) account is not setup; please contact your network service company for assistance.
8. The VPAD10 has been online via a Wireless Network, but still cannot connect to another Computer.
Please check the device driver is installed correctly. If the driver is not installed correctly, press the [Start] -> [Control Panel] ->
[System] -> [Device Manager] -> [Network Adapters], you will find a yellow exclamation mark on the network tag. If a yellow
exclamation mark occurs, please use the driver CD to reinstall the device driver.
9. Good Signal Strength, but cannot connect to the Network.
Please check the TCP / IP address settings are correct or not.
10. If water accidentally penetrates the VPAD10, how to solve this problem?
At this point, do not connect the VPAD10's power supply, or it will cause more serious damage to the VPAD10. Unplug the power
supply and power cord, remove any attached external devices (such as: drive). Dry any liquid that was spilled on the VPAD10;
wipe stains with a soft cloth to reduce potential damage to the unit. Dry the body and other equipment with fans, and then send it to
the nearest VPAD10 repair center to diagnose and repair the VPAD10 by qualied engineers, in order to reduce the damage to the
VPAD10.
11. The computer cannot continue running.
An external or internal storage device could be the cause of this problem as it is not operating properly when storing the content.
29
ViewSonic VPAD10