TEFAL CLIPSO + Precision P4411466 Guide De L'utilisateur page 16

Never wash the seal
in the dishwasher.
To clean the control module and valves
• Remove the control module from the lid: see
"Control module."
• Wash the module with washing-up liquid and then
rinse under running water.
• Visually check that the steam release outlet (A) is
not obstructed
water.
• Check that the operating valve (P) located inside
the unit can move by moving the programme
selector to
Fig. 15
.
• You can clean this valve under running water.
• Also check that the safety valve (Q) works by
pressing hard with a cotton bud in the central part
of the valve, which should be moveable
You can clean this valve under running water.
• Check that the unit seal (O) is properly in place. If
the seal is missing or damaged, leaks can occur in
the unit when your pressure cooker is in use. The
shape of the seal allows it to be removed and
replaced easily. If necessary to replace, this part is
available via our Customer Relations Helpline or
on our website www.tefal.com
• Check the cleanliness of the pressure indicator (D),
you can clean it under running water.
12
- Fig.14
. If it is not, run it under
and pressing with your finger
To clean the lid seal
• After each use, always clean the
seal (G) and its groove.
• Wash the seal using a sponge ,
warm water and washing-up liquid.
• To refit the seal, refer to
and make sure that the words "
face côté couvercle " are against
the lid.
Never dismantle
the control module
Do not forget to
remove the timer.
Never put the
control module in
the dishwasher.
-
Do not use sharp or
pointed objects
when checking the
- Fig. 16
.
safety valve (Q).
Fig. 13