Intended Use - Bodum BISTRO Mode D'emploi

This appliance is intended to be used indoors in household and
similar applications such as: staff kitchen areas in shops, offices
and other working environments, farm houses, by clients in
hotels, motels and other residential type environments, bed and
breakfast type environments.
Do not fill with milk over the maximum level capacity.
Do not use the milk frother to heat oil, or to melt butter.
Do not place any container inside the milk frother – milk must
be removed from the packaging, container, can, etc. before
being put into the carafe.
Do not use the appliance to warm milk for a baby.
WARNING! Never open the lid during the frothing or heating
process.
WARNING! Avoid liquid spillage on the electrical connectors.
WARNING! Handle with care. The heating element surface is
subject to residue heat after use.
Use the product only with the base provided.
The product must not immersed in water for cleaning.
Switch OFF the appliance and disconnect from mains supply
before changing accessories or approaching parts that move
in use.
Be careful when hot liquid is poured from the milk frother, as it
can be ejected out of the appliance due to a sudden steaming.
Clean the product and any accessories thoroughly after each
use. Refer to CLEANING AND CARE section.
7
UNPACKING 1. Remove the product and accessories
AND carefully from their original packaging.
CHECKING
2. Check whether the contents of the
THE
packaging are complete or damaged. If the
PRODUCT
contents of the packing are incomplete or
if damage is detected, please return the
product.
3. Choking hazard! Keep packaging
materials out of reach of young children.
INTENDED USE: This product is suitable for
heating and frothing milk only. Any other
use may result in damage to product and/or
injuries.
BEFORE THE 1. Place the power base on a dry, even, stable
FIRST USE pad.
2. Unwind the power cord until it reaches the
desired length.
3. Connect the mains plug to a suitable mains
power outlet socket.
4. Clean the product and frothing attachment
before using it for the first time in order to
remove any manufacturing residue.
NOTE: Do not immerse the product in water.
Ensure that the connector on the bottom of
the product remains dry.
1. Fill the product with cold water up to the
MAX level and switch ON the product by
pressing the ON/OFF button, the button will
light up. The product will begin to heat.
8
EN