MRA 4025066149421 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
4 Domed Screw M5 x 25mm
4 Plastic washer Ø 12x5mm
2 Neoprene washer 16x5x8mm
2 Neoprene washer 16x5x10mm
1 Edge protector strip
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Unscrew and remove the original screen.
3. Insert the two screws with plastic washers through the holes in the MRA screen.
4. Place the long spacers onto the upper screws and the short spacers onto the lower
screws.
5. Position your MRA screen onto the bracket, and turn in and tighten the screws.
6. Apply the edge guard profile to the exposed rear area of the windshield, starting at
the fairing transition and ending at the opposite side. Cut off the rest if required
7. It is also possible to push the clamping sleeves over the ends of the protective edge
strip and lightly compress these using a pair of pliers to secure the edge strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
YAMAHA Tricity
Article No..
--- Allen key 3mm
10641 Phillips screwdriver
10635
10687
10688
2
Required tools