Operation; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL RG-CT 18/1 Li Mode D'emploi

that marked on the rating plate. Connect the
power cable of the charging unit to a socket
outlet and insert the connector (Fig. 12/Item
N) into the charging jack of the battery pack.
The red LED indicates that charging is in pro-
gress.
3. The charging unit will end the charging au-
tomatically when the battery is fully charged
(after approx. 2 hours). The green LED then
lights up.
The battery pack can become a little warm during
the charging. This is normal. If the battery pack
fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts
If the battery pack still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the power of the cordless grass trim-
mer drops. Never fully discharge the battery pack.
This will cause it to develop a defect.

6. Operation

To obtain maximum performance from your grass
trimmer, please follow these instructions:
•
Never use the grass trimmer without the
guard.
•
Do not mow grass when it is wet. The best
results are achieved with dry grass.
•
To switch on your grass trimmer press the
safety lock-off (Fig. 2 / Item 1) and then press
the On/Off switch (Fig. 2 / Item 2).
•
To switch off your grass trimmer, let go of the
On/Off switch again (Fig. 2 / Item 2).
•
Do not allow the grass trimmer near the grass
until the switch is pressed, i.e. the grass trim-
mer is in operation.
•
To cut properly, swing the machine sideways
while moving forwards. Keep the grass trim-
mer inclined at an angle of approx. 30° while
you do so (see Figs. 17 and 18).
•
If the grass is long, the grass must be cut
shorter in stages, starting from the tip (see
Fig. 19).
Anleitung_RG-CT_18_1_Li.indb 19 Anleitung_RG-CT_18_1_Li.indb 19
GB
•
Use the guard hood to prevent unnecessary
wear.
•
To avoid unnecessary wear, keep the grass
trimmer away from hard objects.
Using the grass trimmer as an edge trimmer
To cut the edges of lawns and fl ower beds, the
grass trimmer can be converted as follows:
•
Remove the battery pack
•
Pull the lock for the rotatable motor head in
the direction of the arrow as shown in Fig. 13.
•
Turn the motor head through 90° in the requi-
red direction until it latches in place.
•
Now you have converted the grass trimmer to
an edge trimmer for cutting the lawn vertically.
7. Cleaning, maintenance and
ordering of spare parts
Before putting away or cleaning the grass trim-
mer, switch off and remove the battery pack.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend that you clean the equipment
immediately after you use it.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be ag-
gressive to the plastic parts in the equipment.
Ensure that no water can get into the interior
of the equipment.
•
Use a brush to remove deposits from the
safety guard.
7.2 Replacing the blade (Fig. 15-16)
IMPORTANT! Be sure to remove the battery
pack before replacing!
•
To remove the blade, push the blade inwards
and remove it through the larger opening as
shown in Fig. 15.
•
To fit the new blade, proceed in reverse order.
Make sure the blade locks into place correctly
as shown in Fig. 16.
7.3 Maintenance
There are no other parts inside the equipment
which require maintenance.
- 19 -
13.12.11 12:49 13.12.11 12:49