Mounting On The Sun Visor; Installation Using The Screw Holes On The Side Of This Product; Installing The Microphone - Pioneer AVH-X8800BT Manuel D'installation

Installation
1
1 Dashboard
4 Attach the trim ring.
1 2
1 Trim ring
2 Groove
Attach the trim ring with the side with a groove facing
downward.
Installation using the screw
holes on the side of this
product
1 Fastening this product to the factory
radio-mounting bracket.
Position this product so that its screw holes are aligned with
the screw holes of the bracket, and tighten the screws at three
locations on each side.
Use either the truss head screws (5 mm × 8 mm) or flush
surface screws (5 mm × 9 mm), depending on the shape of the
bracket's screw holes.
1
4
3
1 Factory radio-mounting bracket
2 If the pawl interferes with installation, you may bend it down
out of the way.
3 Dashboard or console
4 Truss head screw or flush surface screw
Be sure to use the screws supplied with this product.

Installing the microphone

 Install the microphone in a place where its direction and dis-
tance from the driver make it easiest to pick up the driver's
voice.

Be sure to turn off (ACC OFF) the product before connecting
the microphone.
 Depending on the vehicle model, the microphone cable
length may be too short when you mount the microphone on
the sun visor. In such cases, install the microphone on the
steering column.

Mounting on the sun visor

1 Fit the microphone lead into the groove.
2
1 Microphone lead
2 Groove
2 Attach the microphone clip to the sun visor.
1 Microphone clip
2 Clamps
Use separately sold clamps to secure the lead where neces-
sary inside the vehicle.
Install the microphone on the sun visor when it is in the up
position. It cannot recognise the driver's voice if the sun visor is
in the down position.
1
2
1
2
11