Getting Started; Detaching The Front Panel; Setting The Clock; Connecting A Usb Device - Sony CDX-G1102U Mode D'emploi

Getting Started

Detaching the Front Panel

You can detach the front panel of this unit to
prevent theft.
1
Press and hold OFF  until the unit turns
off, press the front panel release button
, then pull the panel towards you to
remove.
Caution alarm
If you turn the ignition switch to the OFF position
without detaching the front panel, the caution
alarm will sound for a few seconds. The alarm will
only sound if the built-in amplifier is used.
Attaching the front panel

Setting the Clock

1
Press MENU, rotate the control dial to
select [GENERAL], then press it.
2
Rotate the control dial to select [CLOCK-
ADJ], then press it.
The hour indication flashes.
3
Rotate the control dial to set the hour
and minute.
To move the digital indication, press SEEK +/–.
4
After setting the minute, press MENU.
The setup is complete and the clock starts.
To display the clock
Press DSPL.

Connecting a USB Device

1
Turn down the volume on the unit.
2
Connect the USB device to the unit.
Connecting Other Portable
Audio Device
1
Turn off the portable audio device.
2
Turn down the volume on the unit.
3
Connect the portable audio device to the
AUX input jack (stereo mini jack) on the
unit with a connecting cord (not
supplied)*.
* Be sure to use a straight type plug.
4
Press SRC to select [AUX].
To match the volume level of the connected
device to other sources
Start playback of the portable audio device at a
moderate volume, and set your usual listening
volume on the unit.
Press MENU, then select [SOUND]  [AUX VOL]
(page 9).
5
GB